Showing posts with label lick tubs. Show all posts
Showing posts with label lick tubs. Show all posts

Wednesday, September 12, 2012

Early Weaning

Weaning our heifer's calves early had me fairly nervous. It was 102 degrees the day following weaning, and 103 degrees the day after that. I was sweating from more than just the heat as our light calves kicked up dust and bawled around the corral. But, although the dust never settled, the cattle did. So far, this has been one of the easiest weanings I can remember. Not one calf has been treated for sickness, they're eating and gaining like crazy, and are calm and relaxed.
These calves were taken off their mothers over a month earlier than we normally would due to the drought this year. Weaning early will allow their mothers to switch from using energy to make milk to using energy to put on condition before winter sets in, and in maintaining their new pregnancy. My dad said he can't remember ever weaning in the middle of August before.
Weaning is one of those ranch practices that is very unique on each operation. What works for one guy may not for the next due to differences in environment, weather, cattle, facilities, disease history and the number of people available to help. Here's what we did this year.

First, we do not precondition, or give any weaning shots. All these calves will be given is a 7-way booster a couple weeks after they're weaned to prevent them from contracting Blackleg. This is a pretty unique management practice, and we are able to do it successfully in part because disease is rare in our area and our cattle are not co-mingled with anyone elses. We do have a complete health program for them, and that is covered further on in this post.
When we wean, it occurs at a corral located a few miles from our house. We sort and load the calves onto our cattle pot, haul them home, and unload them. This means the cows are bawling at a set of corrals far enough away they can't be heard by the calves, and vice versa. Instead of looking for mom, we've found the calves settle down and go to eating faster than when we had the cows right outside the corral.

Keeping the calves full is among our top priorities. They are locked in a smaller pen, shown in the top photo, for the first couple days to prevent them from walking. Walking is when the calves get to walking (as if that wasn't self explanatory) around the corral. Pretty soon they're all worked up, and possibly running, instead of settling down and eating. Walking is bad, and can result in the corral being torn down, increased sickness, reduced feed intake and gain, and higher anxiety levels in the calves. These are all the opposite of what we are trying to accomplish as we wean.
After they're over the initial surprise of being weaned, and we deem they're ready based on extensive observation, we open up the corral and they're given access to a much larger area. Within this area are two bottomless feed bunks we keep full of ground grass hay. They also have access to two round bale feeders from their smaller pen, also full of grass hay. If calves are eating, they aren't thinking about mom as much, and when calves are eating they're going to be gaining. We want to get them gaining as much and as fast as possible; as ranchers we always sell pounds. Plus, full calves are happy calves, and we want them to be happy.



 Every morning we fill the bottomless bunks. Just this week we had to start filling them twice a day because the calves are starting to eat a lot more. As you can see they like to eat and aren't bothered by the loud tractor and hay buster. Feeding time is also when we walk through and observe the calves for any potential problems, concerns or issues. Diligent observation can convert a potentially major issue into a minor concern a lot of the time.


 We also feed lick tubs with our hay. These in the blue plastic containers are supposed to be a special weaning tub, but somehow the order was messed up and we got calving tubs instead (????)


 Here's the ingredient list. Different tub varieties will have different ingredients, and levels of protein, fat, fiber. etc... All tubs provide a lot of vital nutrients and energy, and these (as in, the ones they were supposed to be) are added to the calve's ration to compliment the hay they're also consuming. We are currently switching from these to another, regular calf tub that comes in a cardboard, completely biodegradable tub. If I had the right two labels to compare, I would tell/show you the differences between the two.


 Then there is the water, which is always a critical factor of any ration. Lots of readily available, clean water is essential at all times on our operation, and weaning is no different. The foam is the result of a treatment we put in the water, shown below.


 We add powdered tetracycline, and Corid, to our calves water for health reasons. The tetracycline is a bright yellow powder, and the Corid is a liquid.


 Here is the tetracycline label. We add this to a cistern for a set number of days to prevent respiratory problems (pneumonia) in our freshly weaned calves. In some ways, this combats the same issues that a weaning vaccination program would. In case you missed it, each tub of this costs about $85, and we have to add multiple tubs to the several thousand gallons of water the calves will drink during their time on this. It's not cheap.


 Here's the Corid label. This is used in an attempt to prevent coccidiosis, which can be a very serious and fatal problem in our area. We are doing the 21-day treatment this year. These bottles cost between $95 and $110 each, and so far we've gone through over a half dozen of them. Again, not cheap, but worth it to keep the calves healthy.
We add both of these to a 7,000 gallon cistern, which we've calculated out to gallons per foot. We've also calculated how much of each additive we need to add per foot of water. This way we can turn on the cistern, add the proper amount of Corid and tetracycline, let it fill up a foot, or two or three, then turn it off and have everything mixed and ready to go. A "story pole" is how we measure the depth of the cistern. I know, almost to the minute, how long it takes the well to pump a foot of water into the cistern.


As I mentioned before, so far this year our system is working like a champ. The calves are happy, full and healthy. Nothing better than seeing a corral full of calves lounging around chewing their cuds!

Monday, August 6, 2012

Tricks of the Lick Tub Trade

If you've ever fed lick tubs, you probably know what I'm talking about when I say they are a royal pain in the neck to handle. Weighing in at 250 lbs, these short, stout tubs are beyond my ability to manipulate. Perhaps some of you other ladies, or anyone for that matter, have similar gripes about lick tubs.
Here is the solution I have devised, using tools from the ranching version of "duct tape and twine can fix anything" box.
First, I have my dad or brother place a block under one side of a few tubs wherever they are being stored. This gets them in a position so I can tip them over and roll them around. One key point here is not to have the lick tubs tipped over on their side wherever you are storing them if it's hot. This will result in no lick being left in your tub when you go to feed it....
I roll the chosen tub outside. Then, I go get a chain and the hydrabed. Or, this particular pickup is sporting Mr. Hydrabed's great grandfather, but it still gets the job done. While the tub is still on its side, I wrap the chain over the top and around the sides to the bottom. Then I half twist both ends around each other and wrap it back around the tub on the other two sides. This is just like wrapping ribbon on a present as far as technique goes. Once both ends of the chain are back on top, I tip the tub back over so it's upright again, and adjust the chains if they need it.
I then twist/tie the chain again at the top in a highly technical fashion that would have the men (who are not involved in the feeding of this tub and therefore have no input) cringing. Next I back the pickup up, lower the hydrabed, loop one end of the chain over the arm and secure it, then lift.
To help you visualize this procedure, I took photos the other day:















Once set on the pickup, I unhook the chain attached to the arm, and lower it around the top of the tub like so for transit. I haven't had one rattle off yet from this location. I think if you were going on a fairly smooth road you could just let it hang from the arm just off the pickup bed. I am in no way responsible if you decide to try this and it goes very wrong.



Upon arrival, the hydrabed arm is lifted and the tub rolled off the side. A mild struggle to get it tipped upright ensues. Eventually I win, and everyone is happy - me that it will be empty when I pick it up, and the heifers that they have something to eat.